Hydra the Revenge
Dorney Park · Allentown, Pennsylvania
Height requirement: 54 in (137 cm); top speed 53 mph; 95 ft tall; 7 inversions; opened 2005.
Hydra the Revenge is a steel sit-down roller coaster at Dorney Park in Allentown, Pennsylvania, built by Bolliger & Mabillard. It opened on 7 May 2005. The ride stands 95 ft tall, drops 105 ft, reaches 53 mph and runs 3,198 ft of track. The train has no floor, so riders' feet hang just above the track. It turns riders upside down 7 times.
What riding Hydra the Revenge is like
With 3,198 ft of track for a 95 ft structure, Hydra the Revenge is a long, low-slung ride: most of the time is spent carving through turns and small hills rather than on one big plunge. Its 105 ft drop is longer than its 95 ft height, which means the first drop falls below the level where it starts, into a trench, tunnel or down a hillside. It goes upside down 7 times across 3,198 ft of track, so inversions are spaced out between other elements.
Opened in 2005, it is the 6th oldest of the 8 coasters we list at Dorney Park.
Its 54 in minimum is the strictest at Dorney Park, shared with 1 other coaster. Among extreme-class coasters on Coaster Map the median ride-alone minimum is about 51 in (130 cm), so this rule is higher than is typical for its class.
Going by RCDB's map positions, Hydra the Revenge sits on the north-east side of Dorney Park's coaster line-up. The nearest other coaster is Wild Mouse, roughly 170 m away (48 in minimum), so the two are easy to ride back to back. Next closest is Woodstock Express at about 180 m. Distances are straight-line estimates from map coordinates, not walking routes.
Written from RCDB statistics and the park's published height rule; it describes the layout, not a review.
Hydra the Revenge layout, trains and ride system
To gain height it uses a chain lift hill (95 ft tall, with a 100 ft drop).
RCDB lists 7 track elements for Hydra the Revenge, shown here in the order RCDB lists them:
- Heartline Roll
- Chain Lift Hill (95 ft tall, with a 100 ft drop)
- Inclined Dive Loop (62 ft tall)
- Zero-G Roll
- Corkscrew
- Cobra Roll
- Corkscrew
RCDB counts 7 inversions in total; some elements, such as a cobra roll, turn riders over more than once.
Hydra the Revenge trains and ride system
| Trains | 2 trains with 8 cars per train. Riders are arranged 4 across in a single row for a total of 32 riders per train. |
|---|---|
| Riders per train | 32 |
| Hourly capacity (RCDB) | 1,245 riders per hour |
For families checking heights: it appears on our 54-inch list as a ride-alone coaster.
Elsewhere, Bolliger & Mabillard also built Medusa (Six Flags Great Adventure), Batman: The Dark Knight (Six Flags New England), Wildfire (Silver Dollar City) and Kraken (SeaWorld Orlando). See all Bolliger & Mabillard coasters.
From the RCDB entry for Hydra the Revenge; elements are RCDB's list, not a ride-by-ride account.
Hydra the Revenge stats
| Minimum height | 54 in (137 cm) |
|---|---|
| Park thrill rating | 5 of 5 |
| Height | 95 ft |
| Drop | 105 ft |
| Top speed | 53 mph |
| Track length | 3,198 ft |
| Inversions | 7 |
| Steepest drop angle | 68° |
| Ride time | 2:35 |
| Opened | 7 May 2005 |
| Manufacturer | Bolliger & Mabillard |
| Model | Floorless Coaster / Custom |
| Type | Steel, Sit Down, Extreme, Floorless |
How intense is it?
Intense (extreme)
RCDB classes it as an extreme coaster; Dorney Park rates it 5 out of 5 on its own thrill scale.
Who is it for?
It suits confident thrill seekers who are comfortable with big forces and riders happy to go upside down 7 times. Riders must be at least 54 in (137 cm) tall.
Best seat to ride
The front row gives an unobstructed view, which is the main reason riders choose it on this style of coaster. Outer seats feel more open; the back row is pulled over the drops faster and so tends to give the strongest drop sensation.
General guidance from how this style of coaster moves, not a park rule. See best seat on a roller coaster.
How Hydra the Revenge compares
On our intensity ranking Hydra the Revenge is number 2 of 8 at Dorney Park, where 1 is the most intense. It is the 5th tallest of the park's 8 coasters with a listed height.
If it sounds like too much, the next gentler coaster here is Possessed (185 ft tall, 70 mph, no inversions; 52 in minimum). Ready for more? The next step up is Iron Menace (160 ft tall, 64 mph, 4 inversions; 48 in minimum).
Across all 1486 coasters on Coaster Map, Hydra the Revenge is taller than 61% and faster than 69% of those with a listed figure.
If you liked Hydra the Revenge, try
Similar rides elsewhere on Coaster Map, matched on type, class, builder, size and inversions (the first is the nearest good match within about 700 km, where there is one):
- Batman: The Dark Knight at Six Flags New England: the same Bolliger & Mabillard Floorless Coaster / Custom model; same extreme class; 117.8 ft tall, 55 mph, 5 inversions; 54 in minimum
- Kraken at SeaWorld Orlando: the same Bolliger & Mabillard Floorless Coaster / Custom model; same extreme class; 149 ft tall, 65 mph, 7 inversions; 54 in minimum
- Medusa at Six Flags Discovery Kingdom: the same Bolliger & Mabillard Floorless Coaster / Custom model; same extreme class; 150 ft tall, 65 mph, 7 inversions, 4.5 g; 54 in minimum
Pins show approximate ride positions from RCDB map coordinates. Map data © OpenStreetMap contributors. A text list of every coaster is below the map.
Before you ride Hydra the Revenge
- Measure first: the ride-alone minimum is 54 in (137 cm). Height is checked at the entrance, so ask the ride team before you queue if your child is close.
- Secure glasses, phones and loose items before the 7 inversions; the park posts its loose-article rules at the ride.
- Opening times and ride status: check the Dorney Park app or official site on the day.
Planning for a child? The ride height checker shows every coaster they can ride at Dorney Park.
Frequently asked questions
What is the height requirement for Hydra the Revenge?
Riders must be at least 54 in (137 cm) tall to ride Hydra the Revenge, according to Dorney Park, official ride page (checked 10 Nov 2026). Requirements can change, so confirm at the ride entrance.
How tall is Hydra the Revenge?
Hydra the Revenge is 95 ft tall, with a drop of 105 ft, according to RCDB.
How fast does Hydra the Revenge go?
Its top speed is 53 mph (85 km/h), according to RCDB.
Does Hydra the Revenge go upside down?
Yes. It has 7 inversions.
Is Hydra the Revenge scary?
It depends on the rider, but on intensity: RCDB classes it as an extreme coaster; Dorney Park rates it 5 out of 5 on its own thrill scale. That is RCDB's most intense class.
When did Hydra the Revenge open?
Hydra the Revenge opened on 7 May 2005.
Who built Hydra the Revenge?
Hydra the Revenge was manufactured by Bolliger & Mabillard.
How long is the ride on Hydra the Revenge?
RCDB lists a ride time of 2 minutes 35 seconds over 3,198 ft of track.
How does Hydra the Revenge get up its first hill?
RCDB lists a chain lift hill; it has no launch.
How many people ride Hydra the Revenge at once?
RCDB's train details give 32 seats per train. RCDB lists an hourly capacity of about 1,245 riders.
Is Hydra the Revenge good for first-time riders?
On the numbers: RCDB classes it as extreme; it goes upside down 7 times; it tops out at 53 mph; the minimum height is 54 in. Most first-timers start with a family-class ride with no inversions, so this is better as a step up than a first coaster.
More coasters at Dorney Park
Sorted by ride-alone height, with the lowest height allowed with a companion and any maximum from the official rules.
- Iron Menace (48 in; max 78 in)
- Steel Force (48 in)
- Thunderhawk (48 in)
- Wild Mouse (48 in; 42 in with a companion; max 75 in)
- Possessed (52 in; max 78 in)
- Talon (54 in)
- Woodstock Express
Sources
- RCDB entry for Hydra the Revenge: stats, opening date, manufacturer, type and map position.
- Dorney Park, official ride page: height requirement, thrill rating (checked 10 Nov 2026).
- Dorney Park official site: hours, closures and current ride rules.
Last checked 10 Nov 2026. Found an error? Tell us.